3-56 F650 DIGITAL BAY CONTROLLER GEK-113000-AF3.2 HUMAN-MACHINE INTERFACE (HMI) CHAPTER 3: INTERFACES, SETTINGS & ACTUAL VALUES3.2.6.11 Select main screenThe relay display offers the possibility to select the default main screen. For this purpose, the user must access SelectMain Screen through the HMI. This menu includes the following options:LogotypeThis option selects as main screen the relay logotype including the firmware and boot code versions, the relay model andthe communication parameters for local port COM2.Figure 3-29: Default logotype screenMeteringThis option shows a Metering screen including the phase and ground currents as well as phase-to-phase voltage, and zerosequence voltage values, all of them in primary values.Figure 3-30: Default metering screenAllThis option alternates in time the two previous options.3.2.6.12 Select languageOption only available for versions 1.70 or higher than 5.20.The relay display offers the possibility to select the default language for the relay. For this purpose, the user must accessthe "Select language" menu located at the end of the main menu through the HMI. This menu allows the user to set thedefault language of the relay between English (always available) and second language selected in the relay model.For example one relay in French language (e.g. FC650MZDF2G1HIRF) can be displayed in French or in English only bychanging the language setting in HMI. It is necessary to switch off and on the relay to start working with the new languageconfiguration in the relay. In EnerVista 650 Setup it is possible to select the language for the software (View > Languages).Example of language selection in HMIIa 0.000 Vab 0.000Ib 0.000 Vbc 0.000Ic 0.000 Vca 0.000Ig 0.000 V0 0.000
