GE F650 User Manual

Also see for Multilin F650: Instruction manual User guide Instruction manual Instruction manual User manual

Contents

CHAPTER 3: INTERFACES, SETTINGS & ACTUAL VALUES 3.1 ENERVISTA 650 SETUP SOFTWAREGEK-113000-AF F650 DIGITAL BAY CONTROLLER 3-173.1.6.7 Setting checksum calculationWhen working in offline mode, the Settings Checksum calculation option calculates the CRC of different configuredsettings for the open *.650 file. When a *.650 file is uploaded to the relay, the calculated Settings Checksum and the actualvalue of the Settings Checksum read from the relay (Actual values > Status > System Info) must match.In order to calculate this checksum, the following sections of the * .650 file are considered:• All settings in the relay configuration section (Setpoint > Relay configuration) excluding:– Those communication settings: Setpoint > Product Setup > Communication settings > SerialPorts orNetwork (Ethernet) or Modbus Protocol or Routing– Relay calibration factors– Opening and closing time in the Switchgear section3.1.7 Setpoint menu(*) indicates online only, (**) indicates offline onlySetpointProduct Setup Communications settings for all protocols and physical mediums. ModBus user mapdefinition, fault report, oscillography, data logger demand settings and Time Settings.System Setup General Settings, Flex Curves Definition, Breaker settings, maintenance, switchgearsnapshot events management and Miscellaneous Settings.Protection Elements Phase, Neutral, Ground, Sensitive Ground and Negative Sequence Current Settings.Voltage Elements settings and Power Settings management.Control Elements Setting groups, under- and over-frequency settings, synchrocheck, autoreclose, breakerfailure, VT fuse failure, broken conductor, locked rotor settings management, PulseCounters, Analog comparators, Frequency Rate of Change, Load encroachment, maxnumber of starts, Digital Counters, Cold Load Pickup and PLC Timer MasksInputs/Outputs Contact I/O settings for all boards available in device, Remote Comms Force Outputs andVirtual inputs.Quick Settings Menu that encompass the most important settings to configure the device such as;Current and Voltage sensing or current protection element.Relay Configuration Configuration of Outputs, LEDs, Operations, Protection Elements, Oscillography, ControlEvents, Control Elements, Switchgear, Inputs, Virtual Inputs, Operations and HMI. Wholerelay configuration with internal relay signals or user-definable ones as logic (virtualoutputs).Logic Configuration Logic configuration graphic editor (PLC Editor). It is a PLC Project file editor that contains allthe internal drawings used to make the logic (virtual outputs) based on IEC 61131-3standard. Functional block diagram (FDB).ProcomeConfigurationProcome Configuration tool. Only available for Procome models (5) when communicatingthrough Ethernet with EnerVista 650 SetupIEC103 Configuration IEC103 settings for available IEC103 models (3) when communicating through Ethernetwith Enervista 650 SetupClock (*) Relay synchronization to computer clock or to user-definable date and time. Online modeonly.