6-30 G30 GENERATOR PROTECTION SYSTEM – INSTRUCTION MANUALPRODUCT INFORMATION CHAPTER 6: ACTUAL VALUES66.6 Product information6.6.1 Model informationACTUAL VALUES PRODUCT INFO MODEL INFORMATIONThe order code, serial number, Ethernet MAC address, date and time of manufacture, and operating time are shown here.The rear panel on the device contains similar information. The information is read-only in the software and modifiable onthe front panel. For example, the order code can be corrected using the front panel.ETHERNET MAC ADDRESS — UR devices with firmware 7.0x and above have three Ethernet ports that can be used on threenetworks. The MAC address displays for port 1. The MAC address for port 2 is one higher. The MAC address for port 3 is onehigher than port 2. In redundant mode, the MAC addresses for ports 2 and 3 are the same as port 2.6.6.2 Firmware revisions6.6.2.1 Enhanced and standard front panelsACTUAL VALUES PRODUCT INFO FIRMWARE REVISIONS MODEL INFORMATION ORDER CODE LINE 1:G30-A00-AAA-A0A-A0A-Range: standard GE order code format ORDER CODE LINE 2:A0A-A0A-A0ARange: up to 20 alphanumeric characters ORDER CODE LINE 3: Range: up to 20 alphanumeric characters ORDER CODE LINE 4: Range: up to 20 alphanumeric characters SERIAL NUMBER: Range: standard GE serial number format ETHERNET MAC ADDRESS000000000000Range: standard Ethernet MAC address format MANUFACTURING DATE: Range: YYYY/MM/DD HH:MM:SS OPERATING TIME:0:00:00Range: operating time in HH:MM:SS CT/ VT ADVANCED DIAGACTIVE: NoRange: Yes, No LAST SETTING CHANGE:1970/01/01 23:11:19Range: YYYY/MM/DD HH:MM:SS FIRMWARE REVISIONS G30 RelayREVISION: 7.6xRange: 0.00 to 655.35Revision number of the application firmware. MODIFICATION FILENUMBER: 0Range: 0 to 65535 (ID of the MOD FILE)Value is 0 for each standard firmware release. BOOT PROGRAMREVISION: 7.01Range: 0.00 to 655.35Revision number of the boot program firmware. FRONT PANEL PROGRAMREVISION: 2.01Range: 0.00 to 655.35Revision number of front panel program firmware. COMPILE DATE:2016/09/15 04:55:16Range: YYYY/MM/DD HH:MM:SSDate and time when product firmware was built.