5-36 G60 Generator Management Relay GE Multilin5.2 PRODUCT SETUP 5 SETTINGS5Configure the LED test to recognize User-Programmable Pushbutton 1 by making the following entries in the SETTINGS ÖPRODUCT SETUP ÖØ USER-PROGRAMMABLE LEDS Ö LED TEST menu:LED TEST FUNCTION: “Enabled”LED TEST CONTROL: “ PUSHBUTTON 1 ON ”The test will be initiated when the User-Programmable Pushbutton 1 is pressed. The pushbutton should remain pressed foras long as the LEDs are being visually inspected. When finished, the pushbutton should be released. The relay will thenautomatically start Stage 2. At this point forward, test may be aborted by pressing the pushbutton.APPLICATION EXAMPLE 2:Assume one needs to check if any LEDs are “burned” as well as exercise one LED at a time to check for other failures. Thisis to be performed via User-Programmable Pushbutton 1.After applying the settings in Application Example 1, hold down the pushbutton as long as necessary to test all LEDs. Next,release the pushbutton to automatically start Stage 2. Once Stage 2 has started, the pushbutton can be released. WhenStage 2 is completed, Stage 3 will automatically start. The test may be aborted at any time by pressing the pushbutton.c) TRIP AND ALARM LEDSPATH: SETTINGS Ö PRODUCT SETUP ÖØ USER-PROGRAMMABLE LEDS ÖØ TRIP & ALARM LEDSThe Trip and Alarm LEDs are on LED Panel 1. Each indicator can be programmed to become illuminated when theselected FlexLogic™ operand is in the Logic 1 state.d) USER-PROGRAMMABLE LED 1(48)PATH: SETTINGS Ö PRODUCT SETUP ÖØ USER-PROGRAMMABLE LEDS ÖØ USER-PROGRAMMABLE LED 1(48)There are 48 amber LEDs across the relay faceplate LED panels. Each of these indicators can be programmed to illumi-nate when the selected FlexLogic™ operand is in the Logic 1 state.• LEDs 1 through 24 inclusive are on LED Panel 2; LEDs 25 through 48 inclusive are on LED Panel 3.Refer to the LED Indicators section in chapter 4 for the locations of these indexed LEDs. These settings select the Flex-Logic™ operands that control the LEDs. Support for applying user-customized labels to these LEDs is provided. If the LED1(48) TYPE setting is “Self-Reset” (the default setting), the LED illumination will track the state of the selected LED operand.If the LED 1(48) TYPE setting is ‘Latched’, the LED, once lit, remains so until reset by the faceplate RESET button, from aremote device via a communications channel, or from any programmed operand, even if the LED operand state de-asserts. TRIP & ALARM LEDSTRIP LED INPUT:OffRange: FlexLogic™ operandMESSAGE ALARM LED INPUT:OffRange: FlexLogic™ operand USER-PROGRAMMABLE LED 1LED 1 OPERAND:OffRange: FlexLogic™ operandMESSAGE LED 1 TYPE:Self-ResetRange: Self-Reset, Latched
