4-12 G60 Generator Management Relay GE Multilin4.2 FACEPLATE INTERFACE 4 HUMAN INTERFACES4e) ENTERING INITIAL PASSWORDSTo enter the initial Setting (or Command) Password, proceed as follows:1. Press the MENU key until the SETTINGS header flashes momentarily and the PRODUCT SETUP message appears onthe display.2. Press the MESSAGE RIGHT key until the ACCESS LEVEL message appears on the display.3. Press the MESSAGE DOWN key until the CHANGE SETTING (or COMMAND) PASSWORD message appears on the dis-play.4. After the CHANGE...PASSWORD message appears on the display, press the VALUE UP or DOWN key to change theselection to “Yes”.5. Press the ENTER key and the display will prompt you to ENTER NEW PASSWORD.6. Type in a numerical password (up to 10 characters) and press the ENTER key.7. When the VERIFY NEW PASSWORD is displayed, re-type in the same password and press ENTER.8. When the NEW PASSWORD HAS BEEN STORED message appears, your new Setting (or Command) Password will beactive.f) CHANGING EXISTING PASSWORDTo change an existing password, follow the instructions in the previous section with the following exception. A message willprompt you to type in the existing password (for each security level) before a new password can be entered.In the event that a password has been lost (forgotten), submit the corresponding encrypted password from the PASSWORDSECURITY menu to the Factory for decoding.g) INVALID PASSWORD ENTRYIn the event that an incorrect Command or Setting password has been entered via the faceplate interface three times withina three-minute time span, the LOCAL ACCESS DENIED FlexLogic™ operand will be set to “On” and the G60 will not allowSettings or Command access via the faceplate interface for the next ten minutes. The TOO MANY ATTEMPTS – BLOCKEDFOR 10 MIN! flash message will appear upon activation of the ten minute timeout or any other time a user attempts anychange to the defined tier during the ten minute timeout. The LOCAL ACCESS DENIED FlexLogic™ operand will be set to“Off” after the expiration of the ten-minute timeout.SETTINGSØ SETTINGS PRODUCT SETUP PASSWORD SECURITYACCESS LEVEL:RestrictedCHANGE COMMANDPASSWORD: NoCHANGE SETTINGPASSWORD: NoENCRYPTED COMMANDPASSWORD: ---------ENCRYPTED SETTINGPASSWORD: ---------CHANGE SETTINGPASSWORD: NoCHANGE SETTINGPASSWORD: YesENTER NEWPASSWORD: ##########VERIFY NEWPASSWORD: ##########NEW PASSWORDHAS BEEN STORED
