GE Monogram ZGP484NGRSS Owner's Manual

Contents

Care and CleaningProfessional All-Gas RangeOven lights32A CAUTION: Beforereplacing a bulb,disconnect electrical power to the oven at themain fuse or circuit breaker panel.Eachoven is equipped with halogen light columnslocated on the side walls of the oven. The_ightscome on when the door is opened or when theoven is in a cooking cycle.Eachlight assembly consistsof a removable lightcoverwith two locking clipsand a lightcompartmentwith three halogen bulbs.Besure to let the light cover and bulb coolcompletely.Foryour safety, do not touch ahot bulb with bare hands or a damp cloth.TO remove:1. Removethe racksfrom the oven.See theFul!extensionoven rackssection.2. Usinga 7/16" nutdriver,remove the four nutsholdin,it[he rack supportsto the ovej[ntlwallj_3. Removethe glass light cover by puIIing its buckedge out and rolling it toward you. Do notremove any screws.l; [tl4, Usinggloves or a dry cloth, remove theburned-out light bulb by pullin! it straight out.To replace:Usea new 120-volt Halogenbulb, with G8 pins,not toexceed 25 watts.Replacementbulbsmay be purchasedby calling800.626.2002.OrderPart Number WB25T1006&NOTE:Higherwattagebulbs willdamageyour oven.Usinggloves or a dry cloth, remove the bulbfrom its packaging.Do not touch the bulb withbare fingers. Oil from bare fingers may cause hotspots on the glass surface and lead to prematurefailure of the bulb,If you do touch the gloss,cleonit with alcohol prior to installation.1. Pushthe bulb straight into the receptacleall the way.2. Replacethe light cover, by placing itsfront edge under the front two tabs in the lightcompartment. Rollthe back edge into place,making sure that it isfirmly seated.NOTE:If the locking clips fell from the glass lenscover,hold them on the cover,in the correctposition,while replacingthe cover on the lightcompartment.Place frontedge oflens coverunder fronttwo tabsPressthe light coverinto placeThe light cover must be in place when usingthe oven.3. Reinstallthe rack support. Besure to orient thesupport so that the top tabs for the nuts areclosestto the top of the oven. Lightlysecurewith the four nuts removed earlier,but do notover-tighten or the enamel could be chipped.[ i4. Replacethe racks, Seethe Fullextensionovenracks section.5. Reconnect electrical power to the oven,