CHAPTER 6: MONITORINGPQMII POWER QUALITY METER – INSTRUCTION MANUAL 6–21To assist in troubleshooting, the state of each switch can be verified using these messages.A separate message displays the status of each input identified by the correspondingname as shown in the wiring diagrams in chapter 2. For a dry contact closure across thecorresponding switch terminals the message will read “Closed”.6.3.3 ClockPATH: ACTUAL VALUES Ö A2 STATUS ÖØ CLOCKThe current time and date is displayed in this message. The PQMII uses an internallygenerated software clock which runs for approximately thirty days after the control powerhas been removed. For instructions on setting the clock, see 5.2.6 Clock. The S4 ALARMS/CONTROL ÖØ MISCELLANEOUS ÖØ CLOCK NOT SET ALARM alarm occurs if power has been removedfor longer than thirty days and the clock value has been lost.6.3.4 Programmable MessagePATH: ACTUAL VALUES Ö A2 STATUS ÖØ PROGRAMMABLE MESSAGEA 40-character user defined message is displayed. The message is programmed using thekeypad or via the serial port using the EnerVista PQMII Setup Software. See 6.3.4Programmable Message for programming details. CLOCK [Z] TIME: 12:00:00amDATE: Nov 21 2003 PROGRAMMABLE [Z]MESSAGEPHONE: 905-294-6222www.GEmultilin.com
