CHAPTER 5: SETPOINTSPQMII POWER QUALITY METER – INSTRUCTION MANUAL 5–95.2.6 ClockPATH: SETPOINTS Ö S1 PQMII SETUP ÖØ CLOCK• SET TIME/DATE: These messages are used to set the time and date for the PQMIIsoftware clock.The PQMII software clock is retained for power interruptions of approximately thirtydays. A Clock Not Set alarm can be enabled so that an alarm will occur on the loss ofclock data. The time and date are used for all time-stamped data. If the clock has notbeen set, a “?” will appear on the right-hand side of the displayed time for all time-stamped data. Follow the steps shown below to set the new time and date.FIGURE 5–1: Setting the Date and TimeThe time and date can also be set via Modbus communications. Refer to BroadcastCommand (Function Code 10h) on page 7–10 as an example. CLOCK [Z] SET TIME hh:mm:ss12:00:00 am DATE ZRange: time format as shownMESSAGE SET DATE dd:mm:yyyyNov 21, 2003Range: date format as shownSET TIME hh:mm:ss1 :00:00 am DATE->2SET TIME hh:mm:ss03:0 :00 am DATE->0SET TIME hh:mm:ss03:35:0 am DATE->0SET TIME hh:mm:ss03:35:55 a DATE->mNEW TIMEHAS BEEN STOREDSET DATE mm:dd:yyyyJan 01, 1996SET DATE mm:dd:yyyyOct 0 , 19961SET DATE mm:dd:yyyyJan 01, 1997NEW DATEHAS BEEN STOREDMESSAGESTOREUSE THE VALUEKEYS TO CHANGETHE UNDERLINEDQUANTITIESMESSAGE MESSAGEMESSAGEMESSAGEMESSAGE MESSAGEVALUEENTERENTER
