GE PSS25MCMACC Owner's Manual And Installation

Also see for 21: Owner's manual Use and care & installation guide Use and care & installation guide Owner's manual Use and care & installation guide

Installing and removingpreviouslyinstalled decoratorpanels.Read these instructions completely and carefully.Removing the HandlesIn order to remove the decorator panels and replacewith new panels you need to remove the handles.A T-20 Torxdriver is neede_O I,oosen and remove the 2 screws in theTop Trim,I,oosen and remove tile 2 screws in the bracketthat auaches the Handle to the top of the Door.Grip the Handle firmly and slide upwards.The keyhole slots on the Handle slide offthebuttons on the door.Open the door and slide out the decot_uorpanels.TopTrimScrewsBracketScrewsBracketBu_ons>SlotsInserting the Door PanelsBefore installing the decorator panels, make sure they have been routed out in the proper areas as shown/n thebeginmng of this section. Slide in the panels to perform a toal fit before fastemng down the Handle and Top Trim.Installing the HandlesOnce the panels are htted pmperly, install the Handle and Top Trim.0@Slide the keyhole slots on the Handle do_a_onto the buuons mounted to the til(e of thedoor. Slide the Handle downward until thebracket at the top of the Handle fits flush onthe top of the door.Replace the two screws in the bracket thatattach the Handle to the top of the Door andtighten the s_rews to 45 in-lbs torque.Replace the Top Trim making sure it tits overthe Side Trim and that the locating tabs fit theinside of the Handle profile.Replace the Top Trim screws and tighten to30 in-lbs torque.22