6. Control Functions and Parameter Settings6-57C00-1 RUN/STOP methodsC00-2 Jog stop method= 1: Coast to stop= 2: Deceleration to stop (Ramp down to stop)Coast to stop refers to stopping by turning the VAT2000’s output OFF at the stop commandtime. The motor will slow down by inertiaDeceleration stop refers to stopping the motor by decreasing the VAT2000’s outputaccording currently ramp down time adjusted. The VAT2000 injects a DC Voltage when themotor reaches minimum speed. (all parameters are adjustable).O utpu t freq ue nc yO utpu t freq ue nc yd uring c oa st tos topF.R U ND C B rak eR a m p d ow n to s to pM otor sp ee d du rin gc oa st to s to p(Note) To restart after coast to stop, confirm that the motor has stopped. The inverter maytrip if attempted when the motor is running. (For V/f control)C00-3 Emergency stop (EMS) input logic= 1: Close to stop (when a contact is connected)= 2: Open to stop (when b contact is connected)E M SRY 01 2C00-4 Emergency stop (EMS) modeThe emergency stop comand can be adjusted according the following actions,= 1: Coast to stop, without fault output= 2: Coast to stop, with fault output (When the EMS signal turns ON, the output will be shutoff, and FLT will be ON.)= 3: Ramp down to stop (without fault output)
