GE VAT2000 Instruction Manual

Also see for VAT2000 Series: Instruction manual Instruction manual

Contents

4. Operation Panel (Keypad)4-11(Continued from previous page)Block-C Parameter Mode : Parameters changed infrequently during the normal usageBasic function settingsControl method (C00-0~7)Various setting input selection (C02-0~8)Sequence input terminal function -1 (C03-0~8)Sequence input terminal function -2 (C04-0~9)Sequence input terminal function -3 (C05-0~7, 9)Sequence input terminal function -4 (C06-0~8)Analog input terminal function (C07-0~9)Automatic start setting (C08-0)Parameter protection/Operation Locks (C09-0~7)Custom parameter register (C10-0~7)Operation panel mode setting (C11-0,1,3)Setting input terminal function (C12-0~4)Output terminal function (C13-0~5)Meter output gain (C14-0~1)Status output detection level (C15-0~4)Extend function settingsStart interlock (C20-0~3)Retry/pick-up (C21-0~3)Load setting (C22-0~2,4)Start/stop frequency overload (dual drive) (C23-0~4)Speed detection error monitor (C24-0)High efficiency operation (C25-0~1)Standard serial communications (C26-0~2)Hardware option function settingsControl mode selection (C30-0)Main circuit option selection (C31-0~1)PC Parallel interface option (C32-0~2)Sequence output terminal option (C33-0~1)Serial interface option (C34-0~5)Encoder setting (C50-2)Encoder setting (PM) (C51-0~2)Utility mode U : for future use(Note) At the default setting, only the basic functions are displayed. The extended function, softwareoption function, hardware option function parameters are skipped.Thus, to change these parameters, change parameter A05-0 to 3 (parameter B, C block skipsetting), so that the target parameters are displayed.Fig. 4-4 (3) Parameter configurationknoborkey