3. Test Operation and Adjustment3-15A%min - 1HzLCL FWD REV FLT3-7 Test operation with operation panelThe test operation with the operation panel is performed with the following procedure.CAUTIONMake sure that input signals to digital Inputs, RUN, EMS, PSI1 ~ 5 terminals are OFF(1) Turn ON the power supply.All LEDs will light momentarily on the display, and then" ", " " and " ".will be sequentiallydisplayed.The "LCL" and "Hz" LED will also light.Set the parameter C02-0 to 3 (panel fixed); it will enablethe speed setting from the operation panel. Refer tosection 4-5 for details on changing the parameters.CAUTIONThe motor will run. Confirm the safety around the motor before start(2) Press the key.The “FDW” LED will light and the display will change from “ “ to “ ”. This is because thelocal setting frequency (A00-0) is set to 10Hz as the default setting.CHECK1. Did the motor run?2. Is the run direction correct? Check the wiring and operation if abnormal.3. Is the rotation smooth?(3) Press the key and confirm that the motor runs in reverse.(4) Press the key and stop the motor.(5) Press the key. The motor will forward run at 10Hz.(6) Press the key once. The display will alternate between " " and " ".(7) Press the key once.The display will stop at " ", and the last digit will blink. Now the value set in parameter A00-0may be changed.The digit to change can be selected with the key. The output frequency (digit value) can beincreased / decreased with the knob.
