GE VAT2000 Instruction Manual

Also see for VAT2000 Series: Instruction manual Instruction manual

Contents

6. Control Functions and Parameter Settings6-206-4 Block-C parametersThe Block-C parameters are divided into the basic functions, extended functions and hardware optionfunctions.Block-C parameters (Basic function constants) listApplicationNo. Parameter Unit Default Min. Max. FunctionST V/f VEC PMC00 – Control methods0 Run commandmethod1. 1. 3. Run command method is set.= 1 : F·RUN, R·RUN= 2 : RUN, REV= 3 : Pulse (by Push-buttons)(Pulse inputs for F·RUN andR·RUN)1 RUN/STOP methods 2. 1. 2. Set the stopping method for RUNoperation.= 1 : Coast to stop= 2 : Ramp down to stop2 Jog stop method 2. 1. 2. Set the stopping method for JOGoperation.= 1 : Coast to stop= 2 : Ramp down to stop3 Emergency stop(EMS) input logic1. 1. 2. Emergency stop input logic is set.= 1 : Close to stop= 2 : Open to stop4 Emergency stop(EMS) mode1. 1. 3. Set the stopping method for theemergency stop.= 1 : Coast to stop without a faultoutput= 2 : Coast to stop with a faultoutput= 3 : Ramp down to stop5 Control sourceswitchover method(J1 setting)1. 1. 2. Set whether to validate the remoteoperation sequence for the localoperation mode. Fig 5.2= 1 : Disables = 2 : Enables6 Control sourceswitchover method(J2 setting)1. 1. 2. Select the No. of auxiliary operationsequence input points when the COPcommand is ON. Fig 5.2= 1 : Terminal block input= 2 : Serial input7 Run contact outputcondition selection1. 1. 2. The conditions for turning thesequence RUN output ON are set.= 1 : ON at pre-excitation= 2 : OFF at pre-excitationC01 – Start/stop frequency0 Start frequency Hz 1.0 0.1 60.0 1 Stop frequency(DC brake start)Hz 1.0 0.1 60.0