4. Operation Panel (Keypad)4-184-7 Customising block-B,C parameter1) Block-B, C parameters can be assigned to any Block-A Parameter in the range of A04-0 to A04-7,and can be read and changed in the Block-A Parameter Setting Mode.2) To use this function, set parameter No. to be displayed in A04-0 to 7 in parameter C10-0 to 7.3) The below shown example is valid if the V/f control (constant torque) is enabled, (C30-0=1).A 00-nLocal, Jog frequ encyA 01-nA cce l/decel tim e -1A 02-nTorque B oostA 03-nD C B ra keA 04: C u stomP a ram e ters-0-1-2----7A 05-0P aram eter B , C blockS kip< B lock-A P aram eter > < B lock-C P aram eters >C 10: C usto m P ara-m ete r sele ctionB 10-0A cce leration Tim e 2B 10-1D eceleration Tim e 2C 14-0-0-1-2----7R ead /C h an geP aram eterN um berS ettin g