3. Test Operation and Adjustment3-33-3 Flow of Test OperationStart↓Installation and wiring↓Initial power supply↓Setting of rated items↓Automatic Tuning↓Test operation withoperation panel↓Setting of parameterscompatible withexternal control↓Test operation includingexternal control↓End of test operationFig. 3.1 Test operation procedureCAUTION1. Check that the wiring is correct.2. The power supply must always be kept in the tolerable range.3. Always check that the inverter rating and motor rating match.4. Always correctly install the front cover before turning the power on.5. Assign one worker to operate the switches, etc.6. Refer to the Chapter 6 and observe the precautions when changing the set values such as torqueboost A02-0.Refer to part 3-4 to 3-6Refer to part 3-6Refer to Chapter 5, and perform test operation withthe control input/output from the terminal block.