GE c60 Instruction Manual

Also see for C60: Communications manual Communications guide Instruction manual Instruction manual Instruction manual

Contents

5-22 C60 BREAKER PROTECTION SYSTEM – INSTRUCTION MANUALPRODUCT SETUP CHAPTER 5: SETTINGS5LOAD FACTORY DEFAULTS — This setting is used to reset all the settings, communication, and security passwords. AnAdministrator role is used to change this setting and a Supervisor role (if not disabled) approves it.SupervisorySETTINGS  PRODUCT SETUP  SECURITY  SUPERVISORYThe Supervisory menu settings are available for Supervisor role only, or if the Supervisor role is disabled then for theAdministrator role only.DEVICE AUTHENTICATION — This setting is enabled by default, meaning "Yes" is selected. When enabled, Deviceauthentication with roles is enabled. When this setting is disabled, the UR only authenticates to the AAA server (RADIUS).However, the Administrator and Supervisor (when enabled) remain active even after device authentication is disabled andtheir only permission is to re-enable Device authentication. To re-enable Device authentication, the Supervisor unlocks thedevice for settings changes, then the Administrator re-enables device authentication.BYPASS ACCESS — The bypass security feature provides an easier access, with no authentication and encryption for thosespecial situations when this is considered safe. Only the Supervisor, or the Administrator when the Supervisor role isdisabled, can enable this feature.The bypass options are as follows:• Local — Bypasses authentication for push buttons, keypad, RS232, and RS485• Remote — Bypasses authentication for Ethernet• Local and Remote — Bypasses authentication for push buttons, keypad, RS232, RS485, and EthernetLOCK RELAY — This setting uses a Boolean value (Enabled/Disabled) to indicate if the device accepts settings changes andwhether the device can receive a firmware upgrade. This setting can be changed by the Supervisor role, if it is enabled, orby the Administrator if the Supervisor role is disabled. The Supervisor role disables this setting for the relay to startaccepting settings changes, command changes, or firmware upgrade. After all the setting changes are applied orcommands executed, the Supervisor enables to lock settings changes.Example: If this setting is enabled and an attempt is made to change settings or upgrade the firmware, the UR devicedenies the settings changes or denies upgrading the firmware. If this setting is disabled, the UR device accepts settingschanges and firmware upgrade.This role is disabled by default. SUPERVISORY  DEVICEAUTHENTICATION: YesRange: Yes, No BYPASS ACCESS:DisabledRange: Local, Remote, Local and Remote, Disabled LOCK RELAY:DisabledRange: Enabled, Disabled FACTORY SERVICEMODE: DisabledRange: Enabled, Disabled  SELF TESTSSee below SUPERVISOR ROLE:DisabledRange: Enabled, Disabled SERIAL INACTIVITYTIMEOUT: 1 minRange: 1 to 9999 minutesMode Front panel or serial (RS232, RS485) EthernetNormal mode Authentication — Role Based Access Control (RBAC)and passwords in clearAuthentication — RBAC and passwords encryptedSSH tunnelingBypass access mode No passwords for allowed RBAC levels No passwords for allowed RBAC levelsNo SSH tunneling