CHAPTER 5: SETTINGS PRODUCT SETUPC60 BREAKER PROTECTION SYSTEM – INSTRUCTION MANUAL 5-255Activity Value — 16 bit unsigned5.3.2 Display propertiesSETTINGS PRODUCT SETUP DISPLAY PROPERTIESSome relay messaging characteristics can be modified to suit different situations using the display properties settings.LANGUAGE — This setting selects the language used to display settings, actual values, and targets. This setting displayswhen a language other than English was purchased, and the range depends on the order code of the relay.FLASH MESSAGE TIME — Flash messages are status, warning, error, and information messages displayed in response tocertain key presses during settings programming. These messages override any normal messages. Use this setting tochange the duration of flash messages on the display.DEFAULT MESSAGE TIMEOUT — If the keypad is inactive for a period of time, the relay automatically reverts to a defaultmessage. The inactivity time is modified using this setting to ensure that messages remain on the screen long enoughduring programming or reading of actual values.Enumeration Description1 Authentication Failed2 User Lockout3 FW Upgrade4 FW Lock5 Settings Lock6 Settings Change. Because this can fill the entire event log, it is supported by thealready existing Settings_Change.log file. This event is not required.7 Clear Oscillography command8 Clear Data Logger command (not applicable to all UR products)9 Clear Demand Records command (not applicable to all UR products)10 Clear Energy command (not applicable to all UR products)11 Clear Unauthorized Access command12 Clear Teleprotection Counters command (not applicable to all UR products)13 Clear All Relay Records command14 Role Log in15 Role Log off DISPLAY PROPERTIES LANGUAGE:EnglishRange: English; English, French; English, Russian; English,Chinese; English, German (examples; depends on order code)Visible when language other than English purchased FLASH MESSAGETIME: 1.0 sRange: 0.5 to 10.0 s in steps of 0.1 DEFAULT MESSAGETIMEOUT: 300 sRange: 10 to 900 s in steps of 1 DEFAULT MESSAGEINTENSITY: 25 %Range: 25%, 50%, 75%, 100%Visible when a VFD is installed SCREEN SAVERFEATURE: DisabledRange: Disabled, EnabledVisible when an LCD is installed SCREEN SAVER WAITTIME: 30 minRange: 1 to 65535 min. in steps of 1Visible when an LCD is installed CURRENT CUT-OFFLEVEL: 0.020 puRange: 0.002 to 0.020 pu in steps of 0.001 VOLTAGE CUT-OFFLEVEL: 1.0 VRange: 0.1 to 1.0 V secondary in steps of 0.1
