Garmin AQUAMAP 10x2 Series Owner's Manual

Also see for AQUAMAP 10x2 Series: Installation instructions Owner's manual Installation instructions

Contents

Garmin AQUAMAP 10x2 Series Owner's Manual Manual pdf 106 page image

96 AQUAMAP™ 10x2/12x2 SERIESbitmap (.bmp) file. You can transfer the screenshot to your computer. You canalso view the screenshot in the image viewer.Capturing Screenshots1 Insert a memory card into the card slot.2 Select Settings > Preferences > Screenshot Capture > On.3 Go to a screen you want to capture.4 Hold HOME for at least six seconds.Copying Screenshots to a Computer1 Remove the memory card from the AQUAMAP, and insert it into a cardreader that is attached to a computer.2 From Windows Explorer, open the Garmin\scrn folder on the memorycard.3 Copy a .bmp file from the card and paste it to any location on thecomputer.TroubleshootingMy device will not acquire GPS signalsIf the device is not acquiring satellite signals, there could be a few causes.If the device has moved a large distance since the last time it has acquiredsatellites or has been turned off for longer than a few weeks or months, thedevice may not be able to acquire the satellites correctly.• Ensure the device is using the latest software. If not, update the devicesoftware.• Make sure the device has a clear view of the sky so the antenna canreceive the GPS signal. If it is mounted inside of a cabin, it should be closeto a window so it can receive the GPS signal.My device will not turn on or keeps turning offDevices erratically turning off or not turning on could indicate an issuewith the power supplied to the device. Check these items to attempt totroubleshoot the cause of the power issue.• Make sure the power source is generating power.You can check this several ways. For example, you can check whetherother devices powered by the source are functioning.• Check the fuse in the power cable.The fuse should be located in a holder that is part of the red wire of thepower cable. Check that the proper size fuse is installed. Refer to the labelon the cable or the installation instructions for the exact fuse size needed.Check the fuse to make sure there is still a connection inside of the fuse.You can test the fuse using a multimeter. If the fuse is good, the multimeterreads 0 ohm.• Check to make sure the device is receiving is at least 10 V, but 12 V isrecommended.To check the voltage, measure the female power and ground sockets ofthe power cable for DC voltage. If the voltage is less than 10 V, the devicewill not turn on.• If the device is receiving enough power but does not turn on, contactGarmin product support at support.Garmin.com.My device is not creating waypoints in the correct locationYou can manually enter a waypoint location to transfer and share datafrom one device to the next. If you have manually entered a waypoint usingcoordinates, and the location of the point does not appear where the pointshould be, the map datum and position format of the device may not matchthe map datum and position format originally used to mark the waypoint.Position format is the way in which the GPS receiver’s position appears onthe screen. This is commonly displayed as latitude/longitude in degrees andminutes, with options for degrees, minutes and second, degrees only, or one