63AQUAMAP™ 10x2/12x2 SERIESreference, to help you determine the bearing to an object shown on theradar screen.Nav Lines: Shows the navigation lines that indicate the course you have setusing Route To, Auto Guidance, or Go To.Marks & Waypo: Shows marks and waypoints on the radar screen.Radar Installation SettingsFront of Boat: Compensates for the physical location of the radar when it isnot on the boat axis.Antenna Configuration: Sets the radar antenna size and sets the position inwhich the radar stops.Enable No Xmit Zone: Sets the area in which the radar does not transmitsignals.Front-of-Boat OffsetThe front-of-boat offset compensates for the physical location of the radarscanner on a boat, if the radar scanner does not align with the bow-stern axis.Measuring the Potential Front-of-Boat OffsetThe front-of-boat offset compensates for the physical location of the radarscanner on a boat, if the radar scanner does not align with the bow-stern axis.1 Using a magnetic compass, take an optical bearing of a stationary targetlocated within viewable range.2 Measure the target bearing on the radar.3 If the bearing deviation is more than +/- 1°, set the front-of-boat offset.Setting the Front-of-Boat OffsetBefore you can set the front-of-boat offset, you must measure the potentialfront-of-boat offset.The front-of-boat offset setting configured for use in one radar mode isapplied to every other radar mode and to the Radar overlay.1 From a Radar screen or the Radar overlay, select MENU > Radar Setup> Installation > Front of Boat.2 Turn the knob to adjust the offset.Setting a Custom Park PositionIf you have more than one radar on your boat, you must be viewing the radarscreen for the radar you want to adjust.By default, the antenna is stopped perpendicular to the pedestal when it isnot spinning. You can adjust this position.1 From the radar screen, select MENU > Radar Setup > Installation >Antenna Configuration > Park Position.2 Use the slider bar to adjust the position of the antenna when stopped, andselect BACK.Selecting a Different Radar Source1 Select an option:• From a radar screen or the radar overlay, select MENU > Radar Setup> Source.• Select Settings > Communications > Preferred Sources > Radar.2 Select the radar source.
