3-4Garmin G500H Pilot’s Guide 190-01150-02 Rev. JForewordSec 1SystemSec 2PFDSec 3MFDSec 4HazardAvoidanceSec 5AdditionalFeaturesSec 6Annun.& AlertsSec 7SymbolsSec 8GlossaryAppendix AAppendix BIndex3.1.3 Selecting Page Options1) Change the fields or the setup of a page by pressing the MENU key and makethe necessary adjustments with the MFD knobs.2) Turn the large MFD knob to select desired item.3) Turn the small MFD knob to change the highlighted value.4) Press ENT to accept the displayed value.5) Press the small MFD knob to cancel selection or to end editing.3.1.4 Changing the Navigation Map RangeThe Range (RNG) keys on the right side of the bezel are used to change themap display range. Pressing the RNG key will zoom out (increasing thedisplayed map range) and pressing the RNG key will zoom in (decreasingthe displayed map range). The Map Range is shown on the outer range ring. Themap ranges available are from 250 feet to 500 NM.3.1.5 Decluttering Map PagesThe Map Declutter feature allows the pilot to progressively step throughfour levels of decluttering to remove map information. The declutter level isdisplayed in the DCLTR soft key.Figure 3-5 Map Declutter Soft Key1) There are four levels of decluttering. DCLTR (0) shows the most detail. DCLTR-3removes the most detail.2) While viewing one of the Navigation Map pages, press the DCLTR soft key.Each successive press of the DCLTR soft key will toggle through the declutterlevels. In the following table, features marked with a “•” are shown at theindicated Declutter Level. Features shown at level 0 will be displayed at allDeclutter levels.NOTE: Traffic is automatically decluttered from Nav Map pages when themap scale is above 40 NM.
