102• RFC 2961, RSVP Refresh Overhead Reduction Extensions• RFC 3564, Requirements for Support of Differentiated Service-aware MPLS Traffic Engineering• ITU-T Recommendation Y.1720, Protection switching for MPLS networksMPLS TE configuration task listTask RemarksConfiguring basic MPLS TE N/AConfiguring anMPLS TE tunnelCreating an MPLS TE Tunnel over a static CR-LSPUse either approach.Creating an MPLS TE tunnel with a dynamic signaling protocolConfiguring RSVP-TE advanced features Optional.Tuning CR-LSP setup Optional.Tuning MPLS TE tunnel setup Optional.Configuring traffic forwardingForwarding traffic along MPLS TE tunnels usingstatic routes.Use either approach.Forwarding traffic along MPLS TE tunnelsthrough automatic route advertisementConfiguring traffic forwarding tuning parameters Optional.Configuring CR-LSP backup Optional.Configuring FRR Optional.Inspecting an MPLS TE tunnel Optional.Configuring protection switching Optional.Configuring basic MPLS TEThis configuration task includes the basic configurations required for all MPLS TE features.Before you configure the basic MPLS TE, complete the following tasks:• Configure static routing or IGPs to make sure all LSRs are reachable.• Configure basic MPLS.For configuration information about basic MPLS, see "Configuring basic MPLS."To configure basic MPLS TE:Step Command Remarks1. Enter system view. system-view N/A2. Enter MPLS view. mpls N/A3. Enable global MPLS TE. mpls te Disabled by default.4. Return to system view. quit N/A5. Enter the interface view of anMPLS TE link.interface interface-typeinterface-number N/A
