199Task RemarksConfiguring a PE-CE interface of a PERequired.Perform this task to set up an AC between a PE and aCE.Configuring a remote CCC connection Use one of the approaches according to the MPLSL2VPN implementation method.Perform this task to set up a VC, and bind the VC to anAC.Configuring SVC MPLS L2VPNConfiguring Martini MPLS L2VPNConfiguring Kompella MPLS L2VPNConfiguring basic MPLS L2VPNStep Command Remarks1. Enter system view. system-view N/A2. Configure the LSR ID. mpls lsr-id lsr-id N/A3. Configure basic MPLS andenter MPLS view. mpls N/A4. Return to system view. quit N/A5. Enable L2VPN and enterL2VPN view. l2vpn Disabled by default.6. Enable MPLS L2VPN. mpls l2vpn Disabled by default.Configuring a PE-CE interface of a PEA PE-CE interface of a PE refers to a PE's interface connected to a CE.As shown in Table 2, a PE-CE interface of a PE can use various types of encapsulations.Table 2 Encapsulation types on a PE-CE interface of a PEEncapsulation type ConfigurationEthernet Configuring Ethernet encapsulationVLAN Configuring VLAN encapsulationConfiguring Ethernet encapsulationWhen you configure Martini MPLS L2VPN for a service instance, you can specify the encapsulation typefor the PE-CE interface. When you configure MPLS L2VPN other than the Martini mode, you can only usethe default encapsulation type on the PE-CE interface.By default, a Layer 3 Ethernet interface uses Ethernet encapsulation. For configuration information aboutLayer 3 Ethernet interfaces, see Layer 2—LAN Switching Configuration Guide.
