Baud RateYou can set baud rate to any of the following values:v 300v 600v 1200v 2400v 4800v 9600 (default)v 19200v 38400To change or check the Baud Rate:1. Ensure the printer is powered off (O).2. Press and hold Menu/Enter while powering on (|) the printer. The messageSTARTING UP displays.3. After start-up is complete, release Menu/Enter and the message PRINT OUT=NOdisplays.4. Press ↓ until the message SERIAL INTERFACE displays.5. Press → until the message INTF=xxxxxxxxx displays, where xxxxxxxxx can beSERIAL NO, RS-232C, or RS-422A.6. Press ↓ until the message BAUD=xxxxx displays, where xxxxx can be 300, 600,1200, 2400, 4800, 9600, 19200, or 38400. If you want to select a value other thanthe one displayed, press ← or →.7. To exit from Power On Configuration, press Menu/Enter. Your new value isstored in NVM.Data BitsYou can set data bit to either of the following values:v 8 (default)v 7To change or check the Data Bits:1. Ensure the printer is powered off (O).2. Press and hold Menu/Enter while powering on (|) the printer. The messageSTARTING UP displays.3. After start-up is complete, release Menu/Enter and the message PRINT OUT=NOdisplays.4. Press ↓ until the message SERIAL INTERFACE displays.5. Press → until the message INTF=xxxxxxxxx displays, where xxxxxxxxx can beSERIAL NO, RS-232C, or RS-422A.6. Press ↓ until the message DATA BITS=x displays, where x can be 8 or 7. If youwant to select a value other than the one displayed, press ← or →.7. To exit from Power On Configuration, press Menu/Enter. Your new value isstored in NVM.92 4247 Printer Model A00 User’s Guide
