If you want to save the new value, press ← or → to select either STORE=SAVE (newvalue is stored in NVM) or STORE=CURRENT (new value remains valid until theprinter is powered off (O)). Press Menu/Enter to save the new value.PitchYou can set the horizontal spacing (characters per inch) on your printer to any ofthe following values:v 5 CPIv 6 CPIv 7.5 CPIv 8.5 CPIv 10 CPI (default)v 12 CPIv 15 CPIv 17.1 CPI (DP quality only)v 20 CPI (DP quality only)v Prop (Proportional)To change or check the Pitch value:1. Press Menu/Enter. The message PRINT OUT=NO displays.2. Press ↓ until the message FORM SETTING displays.3. Press → until the message LINE SP=xxxxxxx displays, where xxxxxxx can be 6LPI, 8 LPI, 12 LPI, 3L/30MM, 4L/30MM, 6L/30MM, 8L/30MM, or 12L/30MM.4. Press ↓ until the message PITCH=xxxxxxx displays, where xxxxxxx can be 5 CPI,6 CPI, 7.5 CPI, 8.5 CPI, 10 CPI, 12 CPI, 15 CPI, 17.1 CPI, 20 CPI, or PROP. Ifyou want to select a value other than the one displayed, press ← or →.5. To exit from Program Configuration, press ↓ until the message STORE=QUITdisplays. If you want to exit without saving the new value, press Menu/Enter.If you want to save the new value, press ← or → to select either STORE=SAVE (newvalue is stored in NVM) or STORE=CURRENT (new value remains valid until theprinter is powered off (O)). Press Menu/Enter to save the new value.Pitch LockYou can set this value to:No (default) The host can override the horizontal spacing value (characters perinch).Yes The host cannot override the horizontal spacing value (charactersper inch) that was set through the operator panel.To change or check the Pitch Lock value:1. Press Menu/Enter. The message PRINT OUT=NO displays.2. Press ↓ until the message FORM SETTING displays.3. Press → until the message LINE SP=xxxxxxx displays, where xxxxxxx can be 6LPI, 8 LPI, 12 LPI, 3L/30MM, 4L/30MM, 6L/30MM, 8L/30MM, or 12L/30MM.4. Press ↓ until the message PITCH LOCK=xxx displays, where xxx can be NO orYES. If you want to select a value other than the one displayed, press ← or →.5. To exit from Program Configuration, press ↓ until the message STORE=QUITdisplays. If you want to exit without saving the new value, press Menu/Enter.116 4247 Printer Model A00 User’s Guide
