Once you change the value and save it, press Tear to verify the new tear offposition. If this position is still not where you want it, repeat the above steps tochange the value.1 Form Per PathYou can set this category to either of the following values:1 Form Per Path (default)When forms are loaded from the operator panel or by the software,those forms will use the parameters that are defined for the formspath that is selected in the Paper Paths category.One Form OnlyWhen you load the forms, only the current values on the printerapply to these forms. The printer does not associate the values thatwere previously stored for the selected forms path.To change or check the Paper Path Setup:1. Press Menu/Enter. The message PRINT OUT=NO displays.2. Press ↓ until either the message 1 FORM PER PATH or ONE FORM ONLY displays. Ifyou want to select a value other than the one displayed, press ← or →.3. To exit from Program Configuration, press ↓ until the message STORE=QUITdisplays. If you want to exit without saving the new value, press Menu/Enter.If you want to save the new value, press ← or → to select either STORE=SAVE (newvalue is stored in NVM) or STORE=CURRENT (new value remains valid until theprinter is powered off (O)). Press Menu/Enter to save the new value.PathThe values that are available in this category depend on which paths were selectedin the Power On Configuration menu. See “Power On Configuration” on page 82 forinformation on this menu. The forms path setting can be set to any of the followingvalues:Note: Use the Automatic Sheet Feeder (ASF) only with the Front Push and ManualSheet Feed paths. Remove the ASF to set up your printer for any otherforms path.Front Push (default)Forms are fed from the Front Push tractor.Manual Feed Cut-sheet feeding from the Manual Sheet Feed forms path.This path is always standard with any of the other formspaths.Note: This option always is available with Front or RearPush forms paths.Rear Push Forms feeding from the Rear Push tractor (forms enter andexit from the rear of the printer). If this path is selected, theRear Pull and Push+Pull paths are not available.Note: This value will be the default if you install a secondoptional Rear Push tractor.Rear Pull Forms feeding from the front entry of the printer and pullingChapter 4. Configuring Your Printer 109
