automatic line feed if off, a carriage return is processed normally. This controloverrides the automatic line feed mode set in the operator panel Configurationmenu.If NN is 1, the printer turns automatic line feed mode on.If NN is 0, the printer turns automatic line feed mode off.Select PC Character Set 2 (ESC 6)1B 36This control selects PC character set 2 as the active character set. In PC characterset 2, code points X'03' to X'06', X'15', and X'80' to X'9F' are treated as graphiccharacters (not controls). See “Graphic and Control Character Sequences” onpage 187.Select PC Character Set 1 (ESC 7)1B 37This control selects PC character set 1. In PC character set 1, code points X'03' toX'06', X'15', and X'80' to X'9F' are treated as controls (not printable graphics). See“Graphic and Control Character Sequences” on page 187.Set 12 CPI (ESC :)1B 3AThis control sets the pitch to 12 characters per inch. If the current font isproportionally spaced, this control selects a horizontal resolution of 240 dots perinch. If the active font is OCR, the printer does not prohibit the change in pitch;however, the printed OCR characters may be unreadable by automatic identificationequipment.Unidirectional Printing (ESC <)1B 3CThis command selects unidirectional printing for one line only. The printhead movesto the home position at the left side of the printer and prints one line, left to right.The command is then cancelled by the carriage return that sends the printheadback to the home position.Character Font Image Download (ESC=)1B 3D LL HH FF LF W H CP N XX .. XXThis control downloads special character images.A two-byte count (LL HH) indicates the number of bytes that follow in this control.LL is the least significant byte of the count; HH is the most significant byte of thecount. The number of bytes that follows should equal HH × 256 + LL. If the countequals X'0000', the control is ignored.198 4247 Printer Model A00 User’s Guide
