1. The power switch is located on the lower left side of the printer. Ensure theprinter is powered off (O). DANGER<1> The construction of this printer provides extra protection againstthe risk of electric shock by grounding appropriate metal parts. Theextra protection may not function unless the power cord is connectedto a properly-grounded outlet. This printer has a grounding-type (3-wire)power cord because grounding is necessary. It is the responsibility ofthe customer or the person installing the printer to connect it to aproperly-grounded outlet. Seek professional assistance before using anadapter or extension cord; such a device could interrupt the groundingcircuit.If this printer is connected to an outlet that has been incorrectlyconnected to the building wiring, serious electric shock could result.2. The power connector is located at the lower left rear of the printer. Connect thepower cord to the power connector on the printer. Press firmly to ensure that theplug is securely seated.3. Plug the power cord into a properly-grounded electric receptacle.Changing Display LanguageThe printer default language that appears in the operator panel display of yourprinter is English. You can change the language by following these steps:1. If the printer is powered on (|), power off (O) the printer.2. Enter Power On Configuration mode. Press and continue to hold Menu/Enterwhile powering on (|) the printer until (1) the message STARTING UP appears, (2)the boxes on the operator panel display are solidly filled in, and (3) theprinthead stops. This takes about fifteen seconds. Do not release this key orpress any other keys until this completes.3. Release Menu/Enter. The message PRINT OUT=NO displays.4. Press ↓ until the message FUNCTIONS displays.5. Press → and the message FRONT TEAR=NORM displays.6. Press ↓ until the message MENU=xxxxxxxx displays (where xxxxxxxx can beENGLISH, ITALIANO, FRANCAIS, ESPANOL, DEUTSCH, PORTUGUES,DANSK, or NEDERLANDS).7. Press ← or → until the language you want to use displays.8. Press Menu/Enter to save the setting and exit Power On Configuration mode.Regardless of the language you select, STARTING UP always appears in English.Chapter 1. Printer Setup 19
