Clearing the error logsFor complete information about using the Configuration/Setup Utility program, seethe User’s Guide.To clear the error logs, complete the following steps:1. Turn on the server.2. When the prompt Press F1 for Configuration/Setup is displayed, press F1. Ifyou have set both a power-on password and an administrator password, youmust type the administrator password to view the error logs.3. Use one of the following procedures:a. To clear the BMC system-event log, select Advanced Setup --> IPMI. SetClear System Event Log to Enabled; then, press Esc. The log will becleared at the next system startup, which occurs when you save the settingsand exit the Configuration/Setup Utility program.b. To clear the system-event/error log, select Error logs, and then selectSystem Event/Error Log. When any log entry is displayed, press Enter(Clear event/error logs is highlighted on each entry page).Note: The POST error log is automatically cleared with each system restart.POST error codesThe following table describes the POST error codes and suggested actions tocorrect the detected problems.v Follow the suggested actions in the order in which they are listed in the Action column until the problemis solved.v See Chapter 3, “Parts listing, Type 4364 or Type 4365 server,” on page 59 to determine which componentsare customer replaceable units (CRU) and which components are field replaceable units (FRU).v If an action step is preceded by “(Trained service technician only),” that step must be performed only by atrained service technician.Error code Description Action062 Three consecutive boot failures using thedefault configuration. 1. Update the system firmware to the latest level(see “Updating the firmware” on page 107).2. (Trained service technician only) Replace thesystem board.101, 102 System board failure. (Trained service technician only) Replace the systemboard151 Real-time clock error. 1. Reseat the battery.2. Replace the following components one at a time,in the order shown, restarting the server eachtime:a. Batteryb. (Trained service technician only) Systemboard161 Real-time clock battery error. 1. Reseat the battery.2. Replace the following components one at a time,in the order shown, restarting the server eachtime:a. Batteryb. (Trained service technician only) SystemboardChapter 2. Diagnostics 15
