7. Install the cover (see “Installing the cover” on page 69).8. Slide the server into the rack.9. Connect the cables and power cords.10. Turn on all attached devices and the server.Removing a Remote Supervisor Adapter II SlimLineTo remove a Remote Supervisor Adapter II SlimLine from the server, complete thefollowing steps:1. Read the safety information that begins on page vii and “Installation guidelines”on page 65.2. Turn off the server and peripheral devices and disconnect all power cords andexternal cables; then, remove the cover.3. Grasp the riser-card assembly at the rear edge and lift to remove it from theserver. Set the riser-card assembly aside on a flat, static-protective surface.Remote Supervisor Adapter II SlimLineMounting bracketMounting bracketMounting bracketretention latchRear of system4. Spread the mounting bracket retention latches as you lift the Remote SupervisorAdapter II SlimLine, to disconnect it from the system board; then, lift it out of theserver.Installing a Remote Supervisor Adapter II SlimLineSee the illustration in “System-board optional device connectors” on page 10 for thelocation of the dedicated connector for the Remote Supervisor Adapter II SlimLine.After the Remote Supervisor Adapter II SlimLine is installed, thesystems-management port on the rear of the server is active.Notes:1. When you start the server for the first time after you install a Remote SupervisorAdapter II SlimLine, the startup process will take several minutes longer than atypical startup.2. Earlier versions of the Remote Supervisor Adapter II SlimLine might not work inthis server. See http://www.ibm.com/servers/eserver/serverproven/compat/us/ forthe supported Remote Supervisor Adapter II SlimLine.72 IBM System x3250 Types 4364 and 4365: Problem Determination and Service Guide