6. Place the riser-card assembly on a flat, static-protective surface.7. Carefully grasp the adapter by its top edge or upper corners, and pull theadapter from the riser-card assembly.8. If you are instructed to return the adapter, follow all packaging instructions, anduse any packaging materials for shipping that are supplied to you.Installing an adapterNote: Because of mechanical interference, when the Remote Supervisor Adapter IISlimLine is installed you cannot install an adapter in expansion slot 1.Riser-cardassemblyAdapter supportbracketAdapterExpansion slot 1Expansion slot 2Expansion-slotbracketTo install a replacement adapter, complete the following steps:1. See the documentation that comes with the adapter for instructions for settingjumpers or switches and for cabling.2. Touch the static-protective package that contains the adapter to any unpaintedmetal surface on the server. Then, remove the adapter from thestatic-protective package. Avoid touching the components and gold-edgeconnectors on the adapter.3. Place the adapter, component side up, on a flat, static-protective surface andset any jumpers or switches as described by the adapter manufacturer, ifnecessary.4. To install the adapter in the riser-card assembly, carefully grasp the adapter byits top edge or upper corners, and align it with the expansion slot; then, pressthe adapter firmly into the expansion slot.5. Follow the cabling instructions, if any, that come with the adapter.6. Carefully align the riser-card assembly with the guides on the rear of theserver and with the riser-card connectors on the system board; then, pressdown on the assembly. Make sure that the riser-card assembly is fully seatedin the riser-card connector on the system board.Chapter 4. Removing and replacing server components 71
