To install a Remote Supervisor Adapter II SlimLine, complete the following steps.Remote Supervisor Adapter II SlimLineMounting bracketMounting bracketMounting bracketretention latchRemote SupervisorAdapter II Slimline connector Rear of system1. Put the protective plastic cover on the Remote Supervisor Adapter II SlimLine.2. Turn the Remote Supervisor Adapter II SlimLine so that the keys on theconnector align correctly with the connector on the system board.3. At a downward angle, insert the free end of the adapter under the tab on themounting bracket, aligning the holes in the adapter with the posts on themounting bracket. Rotate the rear of the adapter into the rear mountingbracket, aligning the holes in the adapter with the posts on the rear mountingbracket.4. Press the Remote Supervisor Adapter II SlimLine firmly into the connector andmake sure that all tabs on both mounting brackets secure the adapter in place.Attention: Incomplete insertion might cause damage to the server or theadapter.5. Carefully align the riser-card assembly with the guides on the rear of theserver and with the riser-card connectors on the system board; then, pressdown on the assembly. Make sure that the riser-card assembly is fully seatedin the riser-card connectors on the system board.6. Install the cover (see “Installing the cover” on page 69).7. Slide the server into the rack.8. Connect the cables and power cords.9. Turn on all attached devices and the server.10. See the documentation that comes with the Remote Supervisor Adapter IISlimLine for information about installing the firmware and configuring theadapter. If you have a backup copy of the configuration, restore theconfiguration.Hard disk driveLocate the documentation that comes with the hard disk drive and follow thoseinstructions in addition to the instructions in this section.Attention: To avoid damage to the hard disk drive connectors, make sure that theserver cover is in place and fully closed whenever you install or remove a hard diskdrive.Chapter 4. Removing and replacing server components 73