10410 SCAN OPERATIONN Full/band/programmed scanq Push [V/MHz] to select the VFO mode.• Select the desired frequency band with [BAND], if desired.w Set the squelch level.ePush and hold [SCAN](V/MHz) for 1 sec. to enter the scan-ning type selection.rRotate [DIAL] to select the desired scanning type.• “ALL” for full scan; “BAND” for band scan, “P-LINK x” for pro-grammed link scan (x= 0 to 9), “PROGxx (or scan name if pro-grammed)” for programmed scan (xx= 0 to 24; only programmedscan edge numbers are displayed), “DUP” (appears only whenduplex operation is set) for duplex scan.[DIAL]Full scanBand scanProgrammed link scanPush and holdfor 1 sec.Programmed scanSelectable from “0” to “9.”Selectable from “0” to “24”if programmed.Rotatet Push [V/MHz] to start the scan.• Scan pauses when a signal is received.• Rotate [DIAL] to change the scanning direction. This alsocauses the transceiver to resume scanning.• Push [V/MHz] to stop the scan.• Push [BAND] to change the band during band scan, or changethe scan edge during programmed scan/program link scan.During full/band scan During programmed scanAbout the scanning steps: The selected tuning step in eachfrequency band (in the VFO mode) is used during scan.Duplex scan function: Repeatedly scans two frequencies(transmission/reception) during duplex scan operation.Scan name can be displayed instead of “P-LINK x” for pro-gram link scan (x= 0 to 9), “PROGxx” for programmed scan(xx= 0 to 24) when scan name is programmed and set to ONin DISP set mode. MENU ¶ SET ¶ DISP ¶ SCAN N (p. 129)Scan name is not displayed during scan.
