10510SCAN OPERATION12345678910111213141516171819N Scan edges programmingScan edges can be programmed in the same manner asmemory channels. Scan edges are programmed into scanedges, 0A/0B to 24A/24B, in memory channels.q Push [V/MHz] to select the VFO mode.w Set the desired frequency:± Select the desired band with [BAND].± Set the desired frequency with [DIAL].± Program different frequencies in “11A” and “11B” re-spectively.± Set other data (e.g. frequency offset, duplex direction, tonesquelch, etc.), if desired.ePush and hold [S.MW](M/CALL) for 1 sec. to enter the se-lect memory write mode.• 1 short and 1 long beeps sound.• “ ” indication and memory channel number blink.r Rotate [DIAL] to select the desired programmed scanedge channel from 0A to 24A.t Push and hold [S.MW](M/CALL) for 1 sec.• 3 beeps sound .• The other scan edge channel “B,” 0B to 24B, is automaticallyselected when continuing to push [S.MW](M/CALL) after pro-gramming.y To program a frequency for the other pair of scan edges,0B to 24B, repeat steps w and r.• If the same frequency is programmed into a pair of scan edges,programmed scan will not function.[DIAL]Enterselect memory write mode.Rotate to select“3A.”Push and holdfor 1 sec.“3A” is selected. Return to the VFO mode.Push and holdfor 1 sec.[EXAMPLE]: Programming 145.300 MHz into scan edges 3A.
