727 DV MODE OPERATIONN Break-in communicationThe break-in function allows you to break into a conversa-tion, where the two original stations are communicating withcall sign squelch enabled.qWhile receiving an another station’s communication, pushand hold [RX©CS](8) for 1 sec. to set the communicatingstation’s call sign.• When a call sign has not been received correctly, error beepssound and no call sign is set. Try to set the call sign of a com-municating signal again, or set the call sign manually.w Enter “BK” in DV SET mode. MENU ¶ DV SET ¶ BK(Push [MENU ]), (Push [](2)/[](8), then push [ ](5).)• BK screen is displayed.ePush [](2) or [](8) to turn the Break-in function ON andOFF.• When "ON" is selected, “BK” appears instead of memory chan-nel indicationr Push [ ](5).• Returns to DV SET mode.t Push [MENU ] to return to the frequency screen.“BK” appearsy When both stations are in standby, push [PTT] to transmita break-in call.• The programmed call sign station receives the break-in call aswell as your call sign.u Wait for the reply call from the station who receives thebreak-in call.i After receiving the reply call, communicate normally.o To cancel the break-in function, turn the Break-in functionOFF in the DV SET mode as steps w to t.NOTE: The break-in function is turned OFF automaticallywhen turning transceiver’s power OFF
