15313OTHER FUNCTIONS12345678910111213141516171819[DIAL]Tone scan for repeater toneTone scan for tone squelchTone scan for DTCS squelcht Push [V/MHz] to stop the scan.• If the scan is cancelled before the transceiver detects the toneor code, the set mode contents are not changed.• The detected tone is used for temporary operation only. Thestored tone setting in memory or call channel won’t be changed.NOTE: Tone frequency is over-written automatically when it cor-responds with the scanning tone frequency in tone squelch mode.However, it is not over-written in memory or call channel mode.N Beep tonesYou can select to have confirmation beeps sound at thepush of a switch. The output level can be adjusted within 39levels with “BEEPLV” in SOUNDS set mode (SET). MENU ¶ SOUNDS ¶ BEEPLV (p. 130)(Push [MENU ]), (Push [](2)/[](8), then push [ ](5).)You can select silent operation by turning beep tones OFFwith “KEY B” in SOUNDS set mode (SET). MENU ¶ SOUNDS ¶ KEY B (p. 130)(Push [MENU ]), (Push [](2)/[](8), then push [ ](5).)N Dial speed accelerationThe dial speed acceleration automatically speeds up thetuning dial speed when rotating [DIAL] rapidly.This function can be turned ON and OFF with “DIAL S”(DIAL SPEED) in FUNC set mode (SET). MENU ¶ SET ¶ FUNC ¶ DIAL S (p. 126)(Push [MENU ]), (Push [](2)/[](8), then push [ ](5).)
