335REPEATER AND DUPLEX OPERATIONS12345678910111213141516171819N 1750 Hz toneTo access some European repeaters, the transceiver musttransmit a 1750 Hz tone burst. For such European repeaters,perform the following.• This tone can be use as a ‘Call signal’ in countries out of Europe.qPush and hold [DTMF.M](0) for 1 sec. to select DTMFmemory.w Push [](8) several times (or rotate [DIAL] counter-clock-wise) until “T-CALL” appears.e Push [ ](5) to set.r Push [V/MHz] to exit DTMF memory.t Set the receive frequency (repeater output frequency) .y Set the shift direction of the transmit frequency. (–DUP or+DUP; see p. 32 for details.)u While pushing [PTT], push [SQL] to transmit a 1750 Hztone burst signal.• If “OFF” appears, check the frequency offset or shift direction.(p. 32)• The displayed frequency automatically changes to the transmitfrequency (repeater input frequency).i Push and hold [PTT] to transmit.o Release [PTT] to receive.!0 Push and hold [SQL] to check whether the other station’stransmit signal can be received directly or not, by listeningon the repeater input frequency. CONVENIENT!q Set the receive frequency (repeater output frequency) .w Set the shift direction of the transmit frequency. (–DUP or+DUP; see p. 32 for details.)e Push [PTT] briefly, then push and hold [PTT] again for 1 to2 sec. to transmit a 1750 Hz tone burst signal.• If “OFF” appears, check the frequency offset or shift direction.(p. 32)• The displayed frequency automatically changes to the transmitfrequency (repeater input frequency).r Push and hold [PTT] to transmit; release to receive.
