26Oven will not self-clean. • Check to make sure the cycle is not set for a delayed start. See pages 19-20.• Check if door is closed.• Check if control is in Sabbath Mode. See page 16.• Oven may be over 400° F. Oven temperature must be below 400° F to program aclean cycle.Oven did not clean properly. • Longer cleaning time may be needed.• Excessive spillovers, especially sugary and/or acidic foods, were not removed priorto the self-clean cycle.Oven door will not unlock after • Oven interior is still hot. Allow about one hour for the oven to cool after theself-clean cycle. completion of a self-clean cycle. The door can be opened when the LOCK indicatorword is not displayed.• The control and door may be locked. See page 8.Moisture collects on oven • This is normal when cooking foods high in moisture.window or steam comes from • Excessive moisture was used when cleaning the window.oven vent.There is a strong odor or light • This is normal for a new range and will disappear after a few uses. Initiating a cleansmoke when oven is turned on. cycle will “burn off” the odors more quickly.• Turning on a ventilation fan will help remove the smoke and/or odor.• Excessive food soils on the oven bottom. Use a self-clean cycle.Fault Codes • BAKE or LOCK may flash rapidly in the display to alert you if there is an erroror a problem. If BAKE or LOCK appear in the display, press the Cancel pad.If BAKE or LOCK continue to flash, disconnect power to the appliance.Wait a few minutes, and then reconnect power. If the flashing still continues,disconnect power to the appliance and call an authorized servicer.• If the oven is heavily soiled, excessive flareups may result in a fault code duringcleaning. Press the Cancel pad and allow the oven to cool completely, wipe outexcess soil, then reset the clean cycle. If the fault code reappears, contact anauthorized servicer.Noises may be heard. • The oven makes several low level noises. You may hear the oven relays as they go onand off. This is normal.• As the oven heats and cools, you may hear sounds of metal parts expanding andcontracting. This is normal and will not damage your appliance.There are no beeps and • Oven may be in Sabbath Mode. See page 16.no display.PROBLEM SOLUTIONTROUBLESHOOTING