4-48 Configuring Your ServerCONFIGURING MOTHER BOARD JUMPERSWith the pre-installed SETUP utility, you can set desired passwords to protect the data stored in theserver against access from unauthorized users. When you forget the passwords, however, you maywant clear them. The following describes how to clear these passwords. You can also use thefollowing procedure to clear the CMOS data in the server.IMPORTANT: Clearing the CMOS data resumes the factory-set configuration data. After clearing CMOS, you must run the BIOS SETUP utility andexecute the following menus to reconfigure your mother board.– Load Setup Defaults in the Exit menu– Memory Retest of Memory Configuration in the Advanced menu– Processor Retest of Processor Settings in the Main menuTo clear passwords or the CMOS data, use the jumper switch on the mother board of the server. Thefollowing figure illustrates the jumper switch location.IMPORTANT: Do not change any other switch settings. Any changemay cause the server to fail or malfunction.Jumper strapPASSWORD ClearCMOS ProtectCMOS ClearPASSWORD Protect
