4-10 Configuring Your ServerThe items which can be set on the Main menu screen and their functions are described below.Option Parameter Description Your SettingSystem Time HH:MM:SS Set the system time.System Date MM/DD/YYYY Set the system date.Hard Disk Pre-Delay [Disabled]3 seconds6 seconds9 seconds12 seconds15 seconds21 seconds30 secondsAllows slower spin-up drives tocome ready.Primary IDE MasterPrimary IDE SlaveSecondary IDE MasterSecondary IDE Slave– Shows the information on thedevice connected to eachchannel on the submenu.The settings of some items maybe changed. However, leave theitems as they are at theshipment.Processor Settings – Shows the processor settingssubmenu. See the next page.Language [English (US)]FrançaisDeutschEspañolItalianoSelect which language BIOSdisplays.[ ]: Factory-setIMPORTANT: Check and adjust the system clock before theoperation if any of the following conditions is applicable. After carriage of device After storage of device After the device is entered into the pause state under theenvironmental condition enduring device operation (temperature:10°C - 35°C, humidity: 20% - 80%)Check the system clock at the rough rate of once per month. When thesystem clock is installed in a system requiring high time precision, it isrecommended to use a time server (NTP server).If the system clock is remarkably delayed or advanced as the passage oftime in spite of adjustment, contact your service representative formaintenance.
