Configuring Your Server 4-17CONFIGURING MOTHER BOARD JUMPERSWith the pre-installed SETUP utility, you can set desired passwords to protect the data stored in theserver against access from unauthorized users. When you forget the passwords, however, you maywant clear them. The following describes how to clear these passwords. You can also use thefollowing procedure to clear the CMOS data in the server.IMPORTANT: Clearing the CMOS data resumes the factory-set configuration data. After clearing CMOS, you must run the BIOS SETUP utility andexecute the following menus to reconfigure your mother board.– Load Setup Defaults in the Exit menu– Memory Retest of Memory Configuration in the Advanced menu– Processor Retest of Processor Settings in the Main menu– SATA RAID Enable in the Advanced menu (if your internal SATAhard disk drives are configured with the SATA HostRAID feature)To clear passwords or the CMOS data, use the jumper switch on the mother board of the server.The following figure illustrates the jumper switch location.IMPORTANT: Do not change any other switch settings. Anychange may cause the server to fail or malfunction.JBAT11 2 3J7Pin for protecting/clearing the passwordProtectClear: StrappedProtectClearPin for protecting/clearing the CMOS contents
