Installing the Operating System with Express Setup 5-17Setting for Solving ProblemsSetup the following issue in advance so that your computer can recover from any trouble preciselyand as soon as possible when it should occur.Memory Dump (Debug Information)This section describes the procedures for collecting memory dump (debug information) in theserver.IMPORTANT: Cautions for the Memory Dump The staff of maintenance service representative is in charge ofcollecting memory dump. Customers need only to specify thememory dump. If any trouble occur after specifying the process below, themessage to inform that the system is in short of virtual memorymay appear, but continue to start the system. If you re-start thesystem in such case, memory dump may not be stored correctly.Follow the procedure below to specify.1. Select [Control Panel] and click [System].The [System Properties] dialog box appears.2. Select [Advanced] tab.3. Click [Settings] on the [Startup and Recovery] group box.IMPORTANT: To specify "Complete Memory Dump" to write the debuginformation is recommended.If the mounted memory size is larger than 2GB, "CompleteMemory Dump" cannot be specified so that specify "KernelMemory Dump" instead. Specify the drive where there is a free area more than the size of"the memory capacity mounted on Express server + 12MB". In case the mounted memory size exceeds 2GB due to the addedmemory, change the write debugging information to [KernelMemory Dump] before adding memory. The size of debugginginformation (memory dump) to be taken also changes due toadding memory. Verify the size of the empty space in thedebugging information (memory dump) write destination drive.
