Installing and Using Utilities 6-5Express Setup"Express Setup" is intended for initial setup of the server. Its automatic installation mode guidesthe user easily through the process by detailing specific hardware features and providing screenprompts for software selection and configuration. The program loads the utilities and drivers,applies RAID settings, partitions the disk, and installs the desired operating system.If you install Windows Server 2003 or Windows 2000 Server, after a few tasks are completed, allthat remains to be done is to remove the NEC EXPRESSBUILDER CD-ROM and install theWindows CD-ROM, input a product ID number, and acknowledge the license agreement.IMPORTANT: The Express Setup is intended for the initial setup of the serversystem and, therefore, the Express Setup clears the contents of thehard disk. Once Express setup is started, do not remove "ConfigurationDiskette" from the floppy disk drive without any directions.Tools"Tools" is also intended for initial setup of the server. It provides more installation options thanExpress Setup and permits the user to quickly create utility support disks, run the Off-lineMaintenance Utility and system diagnostic utility, set up a maintenance partition, and update thevarious BIOS programs.NEC Express5800 NEC EXPRESSBUILDER Ver3. xxxx-x Copyright (C) NEC Corporation 2004Tools MenuSave/Restore RAID Configuration DataOff-line Maintenance UtilitySystem DiagnosticsCreate Support DiskSetup Maintenance PartitionBIOS/FW/etc. UpdateRAID Board: PresentTotal Drives: 1Drives in Group: 1Hot Spares: 1RAID Level: 7Write Mode: WRITE_THRUMaint Part: PresentInitialize Remote Management CardSystem ManagementHelpReturn to the Top Menu Save/Restore RAID Configuration DataThe item allows the configuration information on the disk array system to be saved orrestored from the floppy disk.If the HostRAID and LSI-Logic disk array controllers are used together, the configurationinformation of HostRAID is saved or restored. If the Adaptec Zero channel raid controller(ZCR) and LSI-Logic disk array controller are used together, the configurationinformation of ZCR is saved or restored.IMPORTANT: In these cases, If you want to save or restore theconfiguration information of LSI-Logic disk array controller, refer tothe "Power Console Plus User's Guide".
