General Description 2-5Front View with Front Bezel Removed1 Handles (1 at the right and left each)Hold the handles when dismounting/mounting the server from/in the rack.2 Serial port B (COM B) connectorConnect device having a serial interface to this connector (such as remote console PC).3 USB connectors (2 ports)Connect device compliant with the USB interface to the connectors.4 DUMP (NMI) switchPress this switch to dump system memory.5 POWER switchPress this switch to turn on/off the power. Pressing the switch once turns on the power, andthe POWER lamp goes on. Pressing it again turns off the power. Keep pressing the switchfor 4 seconds or more forcibly turns off the power.6 UID (Unit ID) switchPress this switch to turn on/off the UID lamps on the front and rear panels of the server.Pressing the switch once turns on the lamps. Pressing it again turns them off.7 CD-ROM driveThis drive reads data from the CD-ROM.7-1 Disk access lamp 7-2 CD tray eject button 7-3 Emergency hole8 3.5-inch floppy disk driveThis drive reads/writes data from/to the 3.5-inch floppy disk.8-1 Disk access lamp 8-2 Disk slot 8-3 Eject button9 Hard disk baysMount SCSI hard disks in the bays. Each number following the bold-faced number indicatesthe SCSI ID. Dummy sponge blocks are mounted in the bays except 9-1 in the standardconfiguration.10 DISK lamp (green/amber)Hard disk lamp. Each hard disk lamp is green during access to the hard disk. The lampturns amber when the hard disk fails. The lamp flashes switching back and forth betweengreen and amber during build processing (in only disk array configuration).11 SATA hard disk drive baysMount SATA hard disks in the bay. The left side bay is connected to channel 1 of the SATAconnector on the mother board. The right side bay is connected to channel 2 of the SATAconnector on the mother board.See 3 - 7 on the previous page.Hot-plug SCSI hard disk drive model9-19-0SATA fixed hard disk drive model1 2 3 4 5 6 7-1 7-2 7-3 8-1 8-2 8-3 19-29-0 10 9-1
