6. Dial the Speed Dial bin in which the number is to be stored. If you press Hold key, the nextavailable Speed Dial bin will be used. The display shows:ABB XXXX:xxxxxxxxxxxxxIf all Speed Dial bins are used, the display shows “TABLE IS FULL”.7. Press Hold key. The display shows:ABB XXXX-8. Enter the name to be associated with the stored number.Table 1-7 Keys for Entering NamesUse this keypad digit . . . When you want to. . .1 Enter characters: 1 @ [ ¥ ] ^ _ ` { | } Á À Â Ã Å Æ Ç É Ê ì ó 02 Enter characters: A-C, a-c, 2.3 Enter characters: D-F, d-f, 3.4 Enter characters: G-I, g-i, 4.5 Enter characters: J-L, j-l, 5.6 Enter characters: M-O, m-o, 6.7 Enter characters: P-S, p-s, 7.8 Enter characters: T-V, t-v, 8.9 Enter characters: W-Z, w-z, 9.0 Enter characters: 0 ! “ # $ % & ’ ( ) ô õ ú å ä æ ö ü α ε θ В* Enter characters: * + , - . / : ; < = > ? π Σ σ Ω ∞ ¢ £# # = Accepts an entry (only required if two letters on the same key are needed -ex: TOM). Pressing # again = Space. (In system programming mode, use theright arrow Softkey instead to accept and/or add a space.)Clear/Back or DND Clear the character entry one character at a time.Flash Clear all the entries from the point of the flashing cursor and to the right.9. Press Hold key. The display shows:SET ABB10. Press Speaker key.The telephone returns to idle.Storing a Number (When 15-02-60: 1 or 2)To store a Caller ID number in a Common Speed Dial bin:SL1100 ISSUE 2.01-124 Caller IDC
