UNIVERGE SV8100 Issue 5.0Code Restriction 1 - 283Code RestrictionDescriptionCode Restriction limits the numbers an extension user may dial. By allowing extensions to place onlycertain types of calls, you can better control long distance costs. The system applies Code Restrictionaccording to the Code Restriction Class. The system allows for up to 15 Code Restriction Classes and512 extensions .Conditions If a Code Restriction Class has the same entries in both a permit and restriction table, thesystem does not restrict the call. Code Call Digit counting may prevent users from taking advantage of long distanceautomated services like ACD and automated Technical Service. Code Restriction is applied when accessing ARS. If Program 21-01-10 is programmed with an entry other than 0, a call cannot have a talkpath unless the user dials at least the number of digits entered in this option when placingan out going call. This means that an entry of 4 or higher in this program causes a problemwhen dialing 999 or 112. Since these are only 3-digit numbers, the call does not have a talkpath, preventing the emergency dispatcher from hearing the caller. This option should bekept at its default setting of 0 to prevent any problem with dialing 999 or 112. Common Permit Code TableUse the Common Permit Code Table when you have numbers you want all CodeRestriction Classes to dial. To let all users dial 999 or 112, for example, put 999 & 112 in theCommon Permit Code Table. The Common Permit Code Table overrides the Restrict Codeand Common Restrict Code Tables. The system provides 10 tables, with 10 entries in eachtable. Each code is four digits maximum, using 0~9, #, * and the Recall key (as a wild card). Common Restrict Code TableThe Common Restrict Code Table lets you globally restrict certain numbers for all CodeRestriction Classes. Be sure you do not allow the codes you want to restrict in the PermitCode Table or the Common Permit Code Table. The system provides 10 tables, with 10entries in each table. Each code is four digits maximum, using 0~9, #, * and Recall (as awild card). Restrict Code TableWhen you want Code Restriction to allow most calls and restrict only selected calls, use theRestrict Code Table. To block only 1-900 calls, for example, enter 1900 in the Restrict CodeTable. (If the same Code Restriction Class has both Permit and Restrict Code Tables, the
