UNIVERGE SV8100 Issue 5.0Single Line Telephones 1 - 875Single Line TelephonesDescriptionThe system is compatible with Dial Pulse and DTMF analog single line telephones (SLTs). You caninstall single line telephones as On-Premise or Off-Premise extensions. Single line telephone users candial codes to access many of the features available to multiline terminal users. With single linetelephones, you can have your system simulate PBX type operation.There are 320 single line telephones available (note that this number may be restricted due to systempower requirements).When installing single line telephones you must have:o A port on an LCA blade for each single line telephone installed.o If you have DTMF sets, at least one block reserved on the CD-CP00 for analog extension DTMFreception.DTMF Dial Out Timer AddedA program is added for DTMF dialing, Program 20-03-07 : System Options for Single LineTelephones - Trunk Call Dial Forced Sending Start Time (Forced Dial). When Program 20-03-03 :System Options for Single Line Telephones – SLT DTMF Dial to Trunk Lines is set to 0 (receive all digitsbefore sending), the system follows the timers in Program 20-03-04 and Program 20-03-07.The timer in Program 20-03-04 System Options for Single Line Telephones – Dial Sending Start Timefor SLT or ARS resets when the user dials another digit.The timer in Program 20-03-07 System Options for Single Line Telephones – Trunk Call Dial ForcedSending Start Time (Forced Dial) does not reset when a digit is dialed. The user must finish dialing all thedigits before this timer expires (entries: 0~64800 seconds, default: 0).Conditions Dial Pulse single line telephones cannot access any features that require the user to dial #or *. A single line telephone can initiate an Internal Zone page, but cannot receive an InternalZone Page. When a Ring Group call rings a single line station, the BLF indication shows busy. Stutter Dial Tone is supported to Single Line Telephones for Voice Mail Message Waiting.