124Caller ID – Memo Display FunctionDescriptionThe SV9100 can display up to 28 Characters per line and up to three lines of information for a total of 84characters (Maximum 28 digits x 3 lines). If needed, the system can be set to use any one of threeavailable display lines. Additionally, the original CID information can be seen while on the call bypressing the right cursor button on the phone.ConditionsIn a CCIS network the Memo Display Function is only supported for DID calls directedacross CCIS to a remote system.Calls forwarded or transferred across CCIS do not support the Memo Display Function.Memo information cannot be programmed via telephone programming or service accesscode, only via Web Pro and PC Pro.The Memo Display function is only supported on Multiline terminals.The Memo Display function is only supported for incoming trunk calls with Caller IDinformation.The destination station must be idle for the Memo Display function to work.The Memo Display function will only search the Common Speed Dial bins, it will not searchGroup or Station speed dial bins.Find the abbreviation area the side of incoming system when trunk incoming vianetworking.When calls are directed to a virtual extension, the virtual extension must be set to ring forthe Memo Display function to work.Pressing the right Cursor key on the telephone toggles the display between the actualincoming Caller ID information and the Memo Display settings for that incoming Caller IDinformation.When a call is on hold, pressing the Feature Key and the line key the call resides ondisplays the actual incoming Caller ID information.Default SettingsNoneSystem AvailabilityTerminalsAll Multiline Terminals
