979Chapter 23 On-Chip Debug Function (OCD)User’s Manual U16580EE3V1UD0023.2 Connection with N-Wire Type EmulatorTo connect a N-Wire type emulator, it is necessary to mount an emulator connector and circuit forconnection on the target system.Select either the KEL connector, MICTOR connector (Part number: 2-767004-2, distributor: TycoElectronics AMP K.K.), or 2.54 mm pitch 20-pin general-purpose connector as the emulator connector.Connectors other than the KEL connector may not be supported, depending on the emulator, so whenusing a connector, refer to the manual of the emulator used.23.2.1 KEL connectorWhen the IE-V850E1-CD-NW is used, use of the following connector is recommended.Part number• 8830E-026-170S: Straight type• 8830E-026-170L: Right-angle typeFigure 23-1: Connecting N-Wire Type Emulator (IE-V850E1-CD-NW (N-Wire Card))Host machinePCMCIA card slotTarget systemIE-V850E1-CD-NWConnector for emulator8830E-026-170S