Solving Problems 7-3START-UP PROBLEMSThe system displays an invalid configuration error messageat power on when there are the following conditions: the current configuration information doesn't matchconfiguration information stored in Setup, such as whenan internal option is added. the system loses configuration information.If either condition is true, the system displays an “invalidconfiguration information” message.To continue start-up procedures, press Fn-Esc and run theSetup utility to set current system parameters.If an error message appears before the operating systemstarts, look up the error message in the following table.Follow the instructions. If you see other error messages, thehardware might need repair.NOTEWhen the NEC Versa detects an error relatedto display devices, it cannot display on either theLCD or a CRT. The system warns you by beeping.POST Error MessagesThe NEC Versa 2600 has a built-in checking program thatautomatically tests its components when you turn the sys-tem power on. This diagnostic test is called the Power-OnSelf-Test (POST). If the system finds a problem during thePOST, the system displays an error message. If this hap-pens, follow the instructions in the POST error messagetable.
