ENW415-1935 / A / 05.07.19 31operation7.0 operation! WARNING• Do not turn on if children or other at risk individuals are near the appliance.• This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light thepilot by hand.• Before operating, smell all around the appliance area for gas and next to the floor because some gas isheavier than air and will settle on the floor.• Do not use this appliance if any part has been under water. Immediately call a qualified service technicianto inspect the appliance and replace any part of the control system and any gas control which has beenunderwater.FOR YOUR SAFETY READ BEFORE LIGHTINGWHAT TO DO IF YOU SMELL GASLIGHTING INSTRUCTIONSTO TURN OFF GASA. Stop! Read the above safety information on this label.B. Remove batteries from the transmitter and set thermostat to lowest setting, ifequipped.C. Turn off all electrical power to the appliance.D. Open the glass door, if equipped.E. Turn the manual shut-off valve clockwise to the “OFF” position. (Shut-off valve islocated on the flex connector).F. Wait fi ve (5) minutes to clear out any gas. If you smell gas including near thefl oor, STOP! Follow the instructions above in the “WHAT TO DO IF YOUSMELL GAS” section. If you don’t smell gas; close the glass door and go tothe next step.G. Turn the manual shut-off valve counter clockwise to the “ON” position.H. Turn on all electrical power to the appliance and re-install the batteries into thetransmitter. Set thermostat to desired setting, if equipped.I. Turn on the remote wall switch to the appliance.J. If the appliance will not operate, follow instructions “TO TURN OFF GAS” andcall your service technician or gas supplier.A. Set thermostat to lowest setting, if equipped.B. Turn off the remote wall switch to the appliance.C. Turn off all electric power to the appliance if service is to be performed.D. Turn manual shutoff valve clockwise to the “OFF” positon. Do not force.• Turn off all gas to the appliance.• Open windows.• Do not try to light any appliance.• Do not touch any electric switch; do not useany phone in your building• Immediately call your gas supplier from aneighbour’s phone. Follow the gas supplier’sinstructions.• If you cannot reach your gas supplier, callthe fi re department.• If you do not follow these instructions exactly, a fi re or explosion may result causing property damage, personalinjury, or loss of life.• If applicable, always light the pilot whether for the first time or if the gas supply has run out with the glass dooropened or removed.add gas knobadd gas valveEnsure that a continuous gas flow is at the burner before installing the door. When lit for the fi rst time, theappliance will emit an odor for a few hours. This is a normal temporary condition caused by the “burn-in” ofpaints and lubricants used in the manufacturing process and will not occur again. After extended periods ofnon-operation, such as, following a vacation or warm weather season, the appliance may emit a slight odor for afew hours. This is caused by dust particules in the heat exchanger burning off. In both cases, open a window tosufficiently ventilate the room.This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light thepilot by hand.note:O SMANUAL SHUT-OFF(SHOWN IN OFF POSITION)